close
close

How To Install Sharkbite Fittings To Copper Pipe

How To Install Sharkbite Fittings To Copper Pipe. Now, turn on your water and check the connection. When installing sharkbite fittings always measure and mark any copper pipe that the sharkbite fitting will be sliding onto.

EvoPEX Installation SharkBite
EvoPEX Installation SharkBite from www.sharkbite.com

Similarly, are sharkbite fittings up. Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely. Avoid jagged ends with burrs.

Place The Fitting Side Above The Barrel Of The Sharkbite Fitting.

Using a slight twisting motion, push the pipe firmly into the sharkbite fitting until you hit the tube stop. Cut the copper pipe such that the ends are clear and sharp. You should then mark each pipe joint on end to show where the sharkbite fitting will fit.

The Pex Stiffener Does Not Need To Be Removed For Copper Or Cpvc Applications.

How do you install a compression fitting on a copper pipe? Slightly turning the line, push the pipe in the fitting until it reaches the tube stop; Sharkbites are designed to be used with copper piping.

[01:42] Slide On Sharkbite Shutoff Valve.

Now, turn on your water and check the connection. Cut pipe cleanly & squarely. How do you install a compression fitting on a copper pipe?

Likewise, People Ask, Do Sharkbite Fittings.

Avoid jagged ends with burrs. Once the copper pipe bottoms out inside the measuring tool, mark the copper pipe. Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely.

Making Quality Connections Between Copper Pipe And Sharkbite Fittings Is Easy.

You need to insert the pipe through the release collar allowing it to sit against the grab ring. If you are handling copper pipe, remove any sharp edges or burrs. Shut off water and drain pipe.

Leave Comment

Your email address will not be published.