close
close

How To Reset Maytag Washer Error Codes

How To Reset Maytag Washer Error Codes. To clear fault codes, enter service diagnostic mode. To remove the code, press pause or cancel button twice and the power button once.

Maytag Washer Error Codes and Fixes Homebli
Maytag Washer Error Codes and Fixes Homebli from newsstellar.com

How do you reset the code on a maytag washer? There are different methods of resetting a maytag washer. Unplug washer or disconnect power.

This Method Works Best When Trying To Move The Washer Onto The.

If a power failure occurs when the dryer is running, you will see a power failure error code. Unplug washer or disconnect power. Items were detected in the washer during the clean washer cycle.

Then, Reconnect The Washing Machine Cable To The Wall.

Another method for resetting your maytag washer is to press the pause/cancel button, then select the appropriate cycle, and then press the start/pause button. To reset your maytag washer and to reset and clear maytag washer error codes, first check the timer on the washer machine to make sure it is working properly. To clear the code, press the start/pause or power/cancel button.

Plug The Washer Back In.

This is the ‘primary control failure’ code. You have to replace the affected electronics to remove the code. To reset the code of the motherboard hold the start/pause button once to clear the code, then press the start/pause button again to reset the washer.

Lift And The Lower The Lid Six Times Within 12 Seconds.

You can also reset the washer by opening and closing the lid. You can do this by following the steps below. To clear fault codes, enter service diagnostic mode.

Restart The Washer By Pressing The Start/Pause Or Power/Cancel Button Again.

Finally, turn on the washer and it should now be reset. “sd” on display (suds routine) when excessive suds are detected, a suds. One of the ways you can reset your maytag washer is by rotating the main dial in a specific order.

Leave Comment

Your email address will not be published.