close
close

What Is The Best Way To Cut Foam Board Insulation

What Is The Best Way To Cut Foam Board Insulation. The best tool for cutting foamboard/rigid foam insulation. Foam board can be used to insulate any exposed cavity in your home from the top to the bottom, and even the walls if you are remodeling and the drywall is down.

Should You Spray Foam Your Attic Or Use Another Insulator
Should You Spray Foam Your Attic Or Use Another Insulator from theenergypenguin.com

And if you have to cut a small amount, say, less than a couple of inches, this probably is the easiest way. The battery saw is the way to go. Here is how we cut and fit our pir insulation to insulate the walls and roof of the house.

Use A Foam Cutting Saw To Cut Through Larger Pieces.

Once you get the hang of it, it's not too bad. Doing so will make sure that the knife can reach all the way through at the angle you are cutting at with length to spare. I have cut a ton of xps and eps foam.

Pull The Foam Panel From The Wall About 1/2 Inch, Then Push It Back Into Place.

It is messy and can be frustrating to work with. This technique is the same for all rigid insulation such as kings. Eps leaves a lot of dust, xps not so much.

I Use A Jig Saw And A Re Purposed Jigsaw Blade To Make Clean Cuts In Pink Insul.

As before, the best way to cut foam board involves cutting at as much of an angle as possible, and you should also avoid sawing at the foam board. The best solution that i found was a 4 serrated knife blade for my jig saw. To cut foam board, use a pair of heavy duty scissors to make curved or straight lines in the foam.

I Cut Long Piece Using My Battery Operated Circular Saw.

The battery saw is the way to go. Pink foam insulation board is a simple way to add to the r rating of your home. It has the advantage over other knives because the heat seals the styrofoam as it cuts.

Cuts Thru All Kinds Of Rigid Foam Insulation Without Any Mess (The 'Snow' From A Regular Saw Blade) And, At The Right Speed, It Cuts (Not Burns) Its Way Through The.

When cutting look down on the saw and make sure you can see both sides of the saw blade, this sounds a bit weird, but is how to get good 90 deg cuts, you need to be right above the board whilst cutting, loking down on the top of the blade, you see both sides of the blade, if you see more metal one side than the other,. Glued foam board insulation should be allowed to dry for 24 hours before installing drywall or paneling. Foam board insulation are rigid panels of insulation that are made of either polystyrene, polyisocyanurate, and polyurethane, according to the u.s.

Leave Comment

Your email address will not be published.